Gravely 994132, Руководство оператора

Страница: 13 / 48

EN - 11
NOTICE: Refer to Controls and Features on
page 12 during setup.
1. Remove packaging and unit from
container.
2. Unlock and lower operator platform into
operating position. See Set Operator
Platform on page 17.
3. Open bypass valves. See Move Unit
Manually on page 19.
4. Push unit onto a level surface.
5. Close bypass valves.
6. Check tire pressures. See Check Tire
Pressure on page 22 and Specifications
on page 39.
7. Clip cable tie and remove wrap from
steering levers.
8. Check steering lever positions. See
Adjust Steering Levers on page 27.
9. Remove battery from unit and charge.
See Charge Battery on page 25.
10. Check engine oil level and add if needed.
Refer to the engine manual.
11. Check hydraulic oil level and add if
needed. See Check Hydraulic Oil Level
on page 21.
12. Fill engine fuel tank with clean fuel. Refer
to the engine manual.
IMPORTANT: See engine manual for fuel
type.
13. Inspect all hardware and tighten if loose.
14. Check safety interlock system functions
See Check Safety Interlock System on
page 21.
15. Lubricate all fittings. See Maintenance
Schedule on page 20.
16. Place discharge chute in the operating
position.
17. Check that mower deck is level per
factory standards. See Level and Pitch
Mower Deck on page 34.
18. Check all control functions and ensure
unit operates properly. See Controls and
Features on page 12.
SETUP
WARNING: AVOID INJURY.
Read and understand entire
Safety section before
proceeding.
WARNING: FAILURE OF
INTERLOCK together with
improper operation can result
in severe personal injury.
WARNING: FAILURE OF
CONTROLS could result in
death or serious injury.
Figure 3
Transport Position
Operating Position