GRAUPNER Alpha 150Q, Руководство пользователя

Страница: 11 / 48

11 / 48
16571.GPS_Alpha150Q_V2.0sh.en
First use
For the version 16571.GPS the optionally available video goggle (No.
48354) or an optionally available FPV monitor (No. S8405) are
needed for the FPV flight.
Receiver
The integrated HoTT receiver is optimally matched to the copter at
the factory. To program some parameters, refer to the section
"Receiver settings".
Installing the LiPo battery in the copter
To compensate for the weight of the camera, place the LiPo battery
slightly backwards with a self-adhesive Velcro strip on the underside
of the frame and, after fine-tuning the centre of gravity, secure it
against falling with an additional Velcro strip.
Connecting the LiPo battery
To start up the copter, plug the connector of the main battery into
the corresponding socket on the back of the copter and remove it
again after setting the flight mode.
Determining the centre of gravity
Hold the copter in the middle of the upper frame with two fingers
and lift it up. The copter should take a horizontal position. Other-
wise, move the battery accordingly.
Default model memory
07
08
09
VersaCopt
Alpha 150
Alpha 170
Alpha GPS
06
05
10
Alpha 1703D
–––
Xcell 220
Some of the 250 model memories of the supplied transmitter
Graupner mz-12 Pro HoTT are pre-assigned with pattern settings for
different Graupner copters. For the operation of the Race copter
Alpha 150Q GPS it is provided the model memory 10 named with
"
Alpha GPS
". If required, this model memory can also be found in
the download area of the copter product page at www.graupner.de .
Notes
• In both cases, it is recommended not to use the pre-programmed
model memory directly, but to copy it into a free model memory
in accordance with the transmitter manual and then rename it
accordingly.
• In the further course of this manual, the use of this model mem-
ory is assumed.