GRASS VALLEY NV9680, Руководство пользователя

Страница: 30 / 49

14
Operation
Setup Mode
Setup Mode
Setup mode occurs when the NV9680 is disconnected from its network and is freshly
powered up. In setup mode, you can set or change the panel ID, determine software
versions, and perform a test of the panel’s buttons. It is in setup mode that you must initially
set the panel ID.
The panel powers up with 3 buttons illuminated in green:

It can take up to 30 seconds for the menu buttons to appear.
In this illustration, the panel ID was already set to 6412. The “Acquire IP Address” is a status
message during initialization. Until you connect the panel to its network, the status
message will remain the same.
Press the ‘Menu’ button at the far right to access the setup menu:
There are 3 setup menu choices. The ‘Exit’ button at the far right allows you to leave the
menu.
•
Panel ID Entry.
Press the Panel ID Entry button to set the panel ID. A numeric button array appears:
Use the numeric button array as a keypad to enter a panel ID. What you enter appears
on the ‘Panel ID’ button at the top left.
To make the ID permanent, press ‘Save’; to cancel your entry, press ‘Cancel’. In either
case, you will be returned to the setup menu.
NV9654 NV9654
PANEL ID PANEL ID
6541 6541
NO NO
SERVER SERVER MENU MENU
• • •
ENTER ENTER
PANEL PANEL
ID ID
SOFTWARE SOFTWARE
VERSIONS VERSIONS
PANEL PANEL
TEST TEST
MODE MODE
EXIT EXIT
• • •
0 0 CLEAR CLEAR SAVE SAVE EXIT EXIT 1 1 2 2 3 3 4 4 5 5 6 6 7 7 8 8 9 9
PANEL ID PANEL ID
65410 65410
PANEL ID PANEL ID
1234 1234