GRASS VALLEY LDK 4488 SuperXpander, Руководство пользователя, Страница: 26 / 44

26 LDK 4488, LDK 4489 SuperXpander/Xpander User’s Guide (v6.0)
Chapter 3 - Assembly
3.5 Transport position
The SuperXpander/Xpander can be transported in a safe way without the need to remove the
camera and the viewfinder. To bring the unit into transport position proceed as follows:
1. Remove the mains power lead (if used) and the Triax or fiber cable from the
SuperXpander/Xpander. Remove any plugs from the utility power and a script board if
used.
2. If a zoom control is used, remove the zoom control cable from the lens and the zoom
control handle.
3. Turn the bayonet ring lever on the front of the camera upwards to disconnect the lens
from the camera.
4. Remove the lens as described in the section “Mounting a lens” on page 22 .
5. Release lever D to loosen the camera and press lever A to release it.
6. Gently pull back the camera until lever B is pushed out and the camera is locked.
7. Tighten lever D to secure the camera. Leave lever C in the current position.
8. Slide the viewfinder support all the way back and rotate the viewfinder 180 degrees to the
left. Lift and tilt the viewfinder until it is in the lowest horizontal position and fix this
position with the proper levers.
9. The SuperXpander/Xpander is now ready for safe transportation.
3.6 Camera balance
When the lens and camera are mounted on the SuperXpander/Xpander it may be necessary to
balance the SuperXpander/Xpander on the tripod as follows:
1. Loosen the balance knob on the side of the footbed by turning it counterclockwise.
2. Move the footbed back and forth along the tripod until the best balance is achieved.
3. Ensure that the ribs mesh correctly. The red ring on the balance knob should be barely
visible.
4. Tighten the balance knob on the side of the footbed by turning it clockwise.