GRASS VALLEY KAYAK HD, Инструкция по установке и обслуживанию

Страница: 161 / 216

Kayak HD — Installation and Service Manual 161
Control Processor Board Replacement
4. Save a copy of the RAMREC license on an external drive.
5.
Carefully inspect the new controller board.
a. Verify that no damage occurred during shipping.
b. Verify that there are no bent connector pins.
6.
Remove the battery isolation material from BT1 and verify that the
battery ON/OFF switch is in the On position.
Note If the new controller board DIMM(s) are pre-installed from the factory,
proceed to
Step 8 .
7.
Install the DIMM(s) onto the new controller board.
Note When only using one 4GB DIMM, it must be in slot U11.
a. Insert the 4GB DIMM into slot U11.
b. If installing a second 4GB DIMM, insert it into slot U12.
8. Power down the Kayak HD frame by turning the power switch Off on
the existing controller board.
9. Pull out the old controller board.
CAUTION Make sure the ON/OFF switch on the new controller board is in the OFF posi-
tion.
10. Insert the new controller board in the frame slot from which the old
board was removed.
11. Verify the software and license installation.
a.
From the
Home
menu, select the
RAM Recorder
button.
b. The HD RAM Recorder license is displayed.
c. The HD RAM Recorder memory size should also be visible, 4GB or
8GB.
12. Restore all applications and environmental settings.
13.
Verify/set date and time
14. Verify Genlock settings.
The HD RAM Recorder upgrade is complete
Control Processor Board Replacement
When replacing the 671-6630-00, 691-0000-00, or 771-0060-00 control pro-
cessor board, in either the 4U or 8U Frame, verify that the S2 Boot Mode