GRASS VALLEY KARRERA K-FRAME, Инструкция по установке и обслуживанию, Страница: 115 / 278

KARRERA K-FRAME — Installation & Service Manual 115
Registering Karrera K-Frame System Nodes
4. Enter the IP addresses and other information appropriate for your
system.
• The
Panel Name
is used to name the panel, for user convenience. This
field does not affect the operation of the unit.
• The
Frame IP Address
field is for the Karrera K-Frame Video Pro-
cessor.
5.
Click on
Apply
. The new IP addresses will be saved and the Remote Aux
Panel will reset. You should label the panel with its IP address and keep
a record of all IP addresses for future reference.
6. Disconnect the PC, and connect the Remote Aux Panel to the Karrera K-
Frame system network.
7. Repeat this procedure on all the Remote Aux Panels to be used with
your Karrera K-Frame system, entering a unique IP address for each
Remote Aux Panel.
See Remote Aux Panel Registration on page 117 regarding additional config-
uration steps required.
Restoring the Default IP Address
You need to know the current IP address of the Remote Aux Panel in order
to change it using the Web browser. If a panel’s IP address has been
changed and its new value not recorded, it will be impossible to change its
IP address. You can restore the panel to its factory default address, if neces-
sary, with the following procedure.
1. Disconnect the Ethernet cable and the AC power cable from the Remote
Aux Panel.
2. Reconnect only the AC power cable. The panel will enter a diagnostic
mode.
3. Push down and hold any panel button. After three seconds panel
buttons will light up sequentially, indicating different available
diagnostics.
4. When three buttons illuminate, release the held button. This places the
panel in IP Address reset mode, and one button will be flashing.
5.
Press the flashing button. This resets the IP address to factory default.
Registering Karrera K-Frame System Nodes
When IP addresses have been changed on Karrera K-Frame system compo-
nents, or new components are added, the Video Processor Frame needs to
know what new addresses it will use to communicate with those compo-