
40
KAM-DEC-4ADC-MUX Instruction Manual
KAM-DEC-4ADC-MUX Links and Web Pages
Video Input Select Web Page
Use the Video Input Select web page (
) to:
•
Configure input video line rate,
•
Enable or disable Loss of Signal reporting to the Status page and SNMP
monitoring (refer to the 2000NET manual for SNMP information),
•
Configure Vertical Blanking Interval (in Advanced mode), and
•
Select the output timing reference.
View Setting
In the View Selection display, choose the
Standard
radio button to display the
standard settings shown in
. Use the
Advanced
view for
configuring the Vertical Blanking Interval for selecting active video lines to
carry data (see
).
Video Selection Settings
The following functions are provided in the Video Selection section:
•
Input Name – (read-only) signal name is entered on the
I/O Config
page
•
Input Status –
•
Signal presence reported
•
Enable/disable Loss of Signal report to both Kameleon status pages
and SNMP monitoring devices.
Note
The disabling of video and reference Loss of Signal reports and SDI Input
Error warnings allow you to filter these reports from higher level Kameleon
status displays and SNMP monitoring. They will still be reported on this page.
•
Video Format – Composite video format always reported as read-only.
•
Video Line Rate – select 525 or 625 line rate or enable automatic line rate
detection.
•
Flywheel Video Decoder – use of the Flywheel Video Decoder is recom-
mended when working with noisy input signals, such as satellite feeds.
Once the optimum input signal has been acquired, turn the Flywheel
Video Decoder off during normal operation.
For best results, turn the Flywheel Video Decoder on by selecting the
On
checkbox and set the Output Timing Selection source to
Video In
. Locate
the optimum video input signal, then turn the flywheel off (uncheck).
Use
this
link