GRASS VALLEY K2 SAN, Инструкция по установке и обслуживанию

Страница: 284 / 346

Next, reorder adapters.
Reorder adapters
Before beginning this task, make sure of the following:
• Adapters are named correctly
• The control team is created
• The team and loopback are named
1. If not already open, open Network Connections as follows:
a) Open the Windows
Network and Sharing Center
control panel.
b) Click
Change Adapter Settings
.
Network Connections opens.
2. Select
Advanced
, then
Advanced Settings…
3. On the
Adapters and Bindings
tab, order adapters as follows:
• On a Dell R620 or R610 system with four adapters only, the specified order is as follows
Control Connection
FTP-Streaming Connection
Unused Connection 1
Unused Connection 2
• On a Dell R610 system with four adapters and a 10 Gig network interface card installed, the
specified order is as follows
Control Connection
FTP 10G Connection
Unused Connection 1
Unused Connection 2
Unused Connection 3 10G
4. Click
OK
to close and accept the changes.
5. Close Network Connections.
If continuing with network configuration, next set power management settings.
Set power management settings
1. If not already open, open Network Connections as follows:
a) Open the Windows
Network and Sharing Center
control panel.
b) Click
Change Adapter Settings
.
Network Connections opens.
284 K2 SAN Installation and Service Manual 2014 01 27
Administering and maintaining the K2 SAN