GRASS VALLEY GV MATRIX, Руководство пользователя

Страница: 23 / 115

7
GV Matrix
User Manual
Install the Power Cords with their Retaining Clips
Each power inlet has a retaining clip that holds the power cord in place to prevent
inadvertent disconnections.
To install a retaining clip and power cord
1 Slip both ends of the retaining clip into a pair of holes in the plate that extends out
beneath the power inlet on the rear of the frame. Use the holes that position the clip
closest to the body of the power cord connector.
2 Position the clip horizontally and insert the power cord connector into the inlet.
3 Rotate the clip up and press the cord into the gripping loop of the clip.
Power Up the GV Matrix
• To power up the GV Matrix, connect the two power supply cords to AC power.
Notes
• There is no Power switch; the GV Matrix is powered up as soon as either
power supply is plugged into an AC source.
For safety, ensure that the AC supply sockets are located near
the equipment and are easily accessible.
Be sure to disconnect both supply cords before servicing to
avoid electric shock
• Connect the two (redundant) power supplies to separate circuits, if
available, for enhanced failure protection.
Connections
All of GV Matrix’s inputs and outputs are connected on the rear of the frame.
Controller Panel