GRASS VALLEY Encore, Руководство по настройке

Страница: 145 / 426

Encore — Configuration Manual 145
Router Controller Configuration Save and Load
5. Repeat Step 4 until all Sources are displaying
Available
or
Inhibited
as
required. Use the arrow keys if necessary to scroll through the list of
Sources.
Note The Inhibit All button on the Menu bar provides a quick method of setting the
status of all the S ources to Inhibited . The Allow Al l button on the Menu bar
provides a quick method of setting the status of all S ources to Available .
6.
Click the
Add
button in the
Destinations
section of the screen to select the
Destinations to which this rule will apply.
Sources with the
Inhibited
status will not be able to be routed to these
Destinations.
7. Click the
List
button to see the list of Destinations to which the rule will
apply.
8. If necessary add more Destinations to the list by clicking the
Add
button
again, or remove Destinations from the list by clicking on the
Remove
button.
9. When you’re done, click the
Config.
button on the Main menu.
10. When you arrive at the System Configure screen, click the
Obey Rules
button in the Options portion of the screen to enable your configuration
to abide by any rules you’ve defined here and will apply in the
Destination Configure screen.
11. Click the
Save
button and then the
Commit Changes
button.
You may now apply and use your rule(s).
Router Controller Configuration Save and Load
The Router Controller allows multiple configurations to be saved in the
Sharer database and easily reloaded by selecting the desired configuration
name from the list of saved configurations.
The procedures earlier in this section gave instructions on saving the
Router configuration and updating the network with these changes as they
were made. The following generic procedure describes how to save and
load Router configurations at any time.
Saving Router Configurations
Saving with a New Name
1. From the Router Controller Main screen ( Figure 66 on page 104 ), press
the
Save As
button.