GRASS VALLEY 8960ENC -, Инструкция по эксплуатации

Страница: 19 / 52

8960ENC Instruction Manual 19
Configuration
Onboard Module Configuration
To make configuration settings:
1.
Rotate the Function Switch to Bank 1 (2nd LED off) or Bank 2 (2nd LED
on) and to the desired function within that bank.
Note The Function switch should be kept in Bank 2 position E when not in use to
avoid any inadvertent change in configuration. E is an inactive position.
2.
Move the paddle switch to the up or down position and hold
momentarily to set the desired function (refer to
Table 5 on page 20 ).
3.
Return the Function switch to Bank 2 position E when finished with
entire configuration process.
Adding/Deleting Setup for 525 Format
Bank 1, Position 2
Bank 1, position 2 is an overall setup on/off selection which overwrites all
other setup controls. When
Setup
(on) is selected for NTSC 525 format, all
lines in the full-field (FF) picture—which is composed of AP (active picture)
and VI (vertical interval)—have 54 mV setup added. The luma chroma gain
is reduced to provide a 1 V peak-to-peak nominal level. When
No Setup
(off)
is selected, AP and VI have no setup, and luma chroma gain is increased to
provide a 1 V peak-to-peak nominal level.
When Setup is selected, setup can be selectively removed from lines 21, 22
or the vertical interval. When
No Setup
is selected, setup cannot be added to
any line.
Bank 1, Position D
Bank 1, position D controls setup
ON/OFF
for line 21 in both fields.
Bank 1, Position E
Bank 1, position E controls setup
ON/OFF
for line 22 in both fields.
Bank 2, Position F
Bank 2, position F controls setup
ON/OFF
VI lines only both fields.
When
Factory Default
is selected setup is on AP lines, no setup on VI lines, no
setup on line 21, setup on line 22.