GRAPHTEC midi LOGGER GL240, Вопросы и ответы, Страница: 36 / 38

(SD メモリカード /USB メモ
リ )
1
Functions of Software 2
1
9 . Is it possible to connect multiple units?
It is possible. A maximum of 10 units can be connected.
Also, by setting the recording group to the same group, it is possible to control the recording start/stop
all at once.
By setting multiple loggers to the same recording group, a single file of measurement results can be
obtained in addition to individual files.
By setting the group data join together to "On" in the recording settings, the data in the group will be
joined together and output as a CSV file.
10 . How to store the settings of GL100_GL240_GL840-APS in the main unit.
Display "Connection" from [Connect with main unit], and when you cancel [Connect] of the connected
GL240, [Memory of setting conditions] is displayed. Select [Yes] to store the setting conditions in the
main unit. (Some setting conditions are not stored.)
11 . How long is the recording time?
It is depends on the amount of free space on your PC's hard disk.
When the SD memory card in the main unit is full, recording in the main unit will stop, but data transfer to
the PC will continue.
In the case of Off, data recording is performed only on the PC side. The data can be recorded regardless of
the memory of the main unit.
12 . Is it possible to display the AB cursor data values of the data played back by GL100_GL240_GL840-APS
at the same time?
By setting the A cursor and B cursor in the "Digital Display" shown on the right side of the "Waveform
Display" screen, it is possible to display at the same time.
"Digital Display" screen can be displayed simultaneously Minimum value, Maximum value, Average
value, Peak value etc.
13 . Is it possible to change the span and position?
The span and position can be changed by using [Y-axis scale expansion/reduction] and [Move up/
down position] in the lower part of GL100_GL240_GL840-APS.
To select the channel you want to move or change, click on the channel number in the digital value
display on the right side.
When CH (ALL) is selected, the setting is reflected on all channels.