4-8
[Options] tab
Use this tab to make settings such as Scaling and Offset, and to select whether or not
to cut the paper after printing.
Scaling
Use this parameter to specify the scaling ratio.
Printing is normally performed at the 100% setting.
The Scaling setting can be made in the 25 to 400% range, in 1% units.
Examples
To enlarge an A2-size image to A1-size, specify 141%.
To reduce an A1-size image to A2 size, specify 70%.
Offset
Use this parameter to move the printing origin.
If a check is inserted in the "Offset" checkbox, the new origin position can
be specified by entering values in the X and Y directions, in 0.1-mm
increments.
Paper cut
Use this parameter to select whether or not to perform cutting of the paper
after a printing operation. Select either "Perform cut" or "No cut".
This parameter can only be specified when the paper source is "Roll
Paper".
Drying Time
Use this parameter to specify the length of time between data output
operations.
Distance
adjustment
Use this parameter to adjust the distance in the paper feed direction.
If the paper type, thickness or other factors cause a discrepancy in the
paper feed distance to occur, enter a corrective value.
The corrective value can be set in the range from -3.00% to +3.00%, in
increments of 0.01%.
Example
If a 1 m (1000 mm) line segment is printed as 995 mm, set a corrective
value of 0.5%.
(1000 - 995) __ 1000 x 100 (%) = 0.5%
