GRAPHTEC FC7000-100, Руководство по обслуживанию

Страница: 92 / 146

FC7000-UM-251-9370 7-26
7. ADJUSTMENT
7.3.13 Confirming the 2-Pen Model (2-pen model)
This setting will confirm that the plotter is a 2-pen model.
If you replace the main board, use the following procedure to make the 2-pen model setting.
(1) Load an A2 or larger size sheet of paper in the plotter.
(2) Enter the adjustment menu (see Section 7.3.6).
(3) Press the MENU key to display the menu shown below.
SENSOR TEST
KEY TEST
PEN FORCE
XY GAIN
(4) Press the NEXT key until the menu shown below is displayed.
LED PEN POS ADJ
2 PEN TYPE MACHINE
RM SENSOR LEVEL
RM DEBUG
(5) Press the F2 key to display the menu shown below.
2 PEN SYSTEM
ENABLED*
DISABLED
(6) Change DIP switch 6 of SW1 from ON to OFF if the 2-pen system is disabled.
FC7000MK2-60 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
FC7000-75/MK2-75 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
FC7000-100/MK2-100 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
FC7000-130/MK2-130 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
FC7000-160/MK2-160 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
(7) Turn off the power to exit from the adjustment menu.