GRAPHTEC FC5100A-100, Руководство пользователя

Страница: 144 / 201

Background Settings: Background Settings for HP-GL
144
• Press the F3 key to select MANUAL or press the F4 key to select PROGRAM. A
blinking cursor appears beside your choice.
• Press the ENTER key to register your setting and to proceed to the next menu.
Press the NEXT key if you wish to bypass this setting with no changes.
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.
Initial Blade Con-
trol Position (INI-
TIAL BLADE
CONTROL)
This function specifies the position at which initial blade control is performed
(for more information about initial blade control see Adjusting the Blade Offset
Angle .)
When 2mm BELOW is selected, initial blade control is performed 2mm below the
starting point of cutting.
When OUTSIDE is selected, initial blade control is performed outside of the
effective cutting area.
• Press the F3 key to select 2mm BELOW or press the F4 key to select OUTSIDE.
A blinking cursor appears beside your choice.
• Press the ENTER key to register your setting and to proceed to the next menu.
Press the NEXT key if you wish to bypass this setting with no changes.
CONDITION PRIORITY
MANUAL .
PROGRAM .
PEN SELECT
ENABLED .
DISABLED .
INITIAL BLADE
CONTROL POSITION
2mm BELOW .
OUTSIDE .
LENGTH UNIT
METRIC .
INCH .