GRAPHTEC CS1000EV, Руководство пользователя

Страница: 64 / 75

CS1000EV/1100EV 6 – 3
6. TROUBLESHOOTING PROCEDURES
6.4 The Control Panel’s Red ERROR Lamp Is Flashing
Cause Remedy
The scanner was turned on with Open the cover and remove the document (see
a document left loaded inside it. Section 5.4, “Removing a Jammed Document”).
The top cover was opened during Press the control panel’s STOP button to cancel
a scanning operation or while a document the error state. Next, remove the document by
was left in the scanner. pressing the FORWARD/REVERSE button to
advance the document.
6.5 The Document Isn’t Properly Fed to the Initial Scan-
ning Position
Cause Remedy
The target document is curled up, Load the document after placing it inside the
wrinkled, too thin, or otherwise poorly carrier sheet provided (see Section 4.3, “Using
suited to proper feeding. the Carrier Sheet”).
You are using the EV document hold-down Replace the EV hold-down unit with the
unit when you should be using the standard standard unit, or, place the document in the
hold-down unit for a thin document. carrier sheet provided as a standard accessory.
6.6 After Scanning, Image Data Becomes Black or White
Cause Remedy
The document was loaded with its target Load it in the scanner with its target surface
surface facing up instead of down. (the surface to be scanned) facing down.
The Threshold Value setting was Set the Threshold Value setting again (it can be
inappropriate for the target document. controlled from the scanning software provided).
6.7 The Image Quality Has Dropped
Cause Remedy
The document hold-down unit is not Open the top cover and check the document
inserted correctly. hold-down unit.
The transparent contact plates over Clean the transparent contact plates (see
the image sensors are dirty Section 5.1, “Cleaning the Image Sensors”)
The carrier sheet is not used with
Use the carrier sheet.
transparent or translucent documents.