GRAPHTEC CELITE-50, Руководство пользователя

Страница: 36 / 128

2-14
Chapter 2 Basic Operations
2.8
Ordinary Care
Conduct ordinary care while being careful of the items listed below.
•
Refrain from lubricating the mechanical section.
•
To clean the main unit, wipe the unit with either a dry cloth or a cloth soaked in a diluted neutral detergent.
Refrain from using substances such as paint thinner, benzene, or alcohol, etc. as these will damage the
surface.
Media Sensor
Push Roller
Cutting Mat
•
I f the cutting mat is dirty, clean it by wiping is with a dry cloth.
I f the cutting mat is very dirty, wipe it with a cloth moistened with
alcohol or a diluted neutral detergent.
•
Dust or dirt, etc. attaching to the sensor unit which scans the media or the
roller unit that transports the media can cause the device to malfunction.
Regularly wipe these components with a cloth or cotton swabs moistened
with alcohol or a diluted neutral detergent.
*
Absolutely refrain from using benzene, paint thinner, etc.
•
I f the Y-rail sliding surface has become dirty, gently wipe off the dirt with a clean dry cloth.
* Lubricant seeps out onto the sliding surface. Avoid forcefully wiping this off.
Storage Method
Be careful of the following items for storage when the device will not be used.
•
Be sure to remove the tool from the tool holder when storing the device.
•
Prevent dust from accumulating by covering the main unit with a cover cloth cover.
•
Refrain from storing the device in a location exposed to direct sunlight or subject to high temperatures and
humidity.
•
Raise the media set levers and place the push rollers in their unlocked state for storage.
Cleaning the Cutter Pen
Media scraps, etc. attached to the tip of the cutter blade will lower the quality of the cuts.
Regularly clean the cutter pen to remove any media scraps, etc.
CAUTION
•
Be very careful when handling the cutter blade to avoid cutting your hands, etc.
•
Clean the tip of the cutter blade with air or a soft material. Using a stiff material can cause the blade to chip or break.
Blade Tip Cap
Blade Tip
Cap Jig
Cutter Blade
1.
Align the red line on the cutter pen with "0" to place it in a state
where the blade is not protruding.
2.
Turn the Blade Tip Cap to counterclockwise to remove it by using
the Blade Tip Cap Jig.
Attach the Blade Tip Cap Jig to the Blade Tip Cap, and then
remove the Blade Tip Cap while holding the number part of
cutter pen as shown in the picture.
3.
Clean the removed blade tip cap and cutter blade with air or a
soft material.
4.
Attach the Blade Tip Cap to the Cutter pen, and then manually turn the Blade Tip Cap clockwise to install it.
Securely tighten the Blade Tip Cap by using the Blade Tip Cap Jig.