Function Settings and Operations
4-19
4.15 Expanding the Cutting/Plotting Area
This function allows the width of the cutting/plotting area to be extended by 9.5 mm on both sides, for a total
increase of 19 mm, enabling cutting to be performed up to the area in which the pinch rollers are positioned.
(1) Press the
(PAUSE) key
to switch to PAUSE mode.
(2) Press the
(NEXT)
or
(PREV.) key
until the following menu is displayed.
A D V A N C E D F U N C .
(3) Press the
(ENTER) key
, and then press the
(NEXT)
or
(PREV.) key
until the following menu is displayed.
E X P A N D
(4) Press the
(ENTER) key
to display the plotting-area width-setting menu.
E X P A N D O F F
Press the
or
key
to select
"ON"
or
"OFF,"
and then press the
(ENTER) key
to confirm. To cancel the selection, press the
(NEXT)
or
(PREV.) key
.
(5) If the settings are not changed, press the
(PAUSE) key
to cancel PAUSE
mode. If the settings are changed, the media-type selection menu is displayed.
R O L L 2 P R E S S E N T R
(6) For details on the media loading and selection procedures, refer to "2.3 Loading
the Medium."
CHECKPOINT
This setting is retained in the memory even when the power is turned off.
B L A D E W A R E S E T U P
C U T L I N E P A T .
T A N G E N T I A L
I N I T . B
P E N U P S P E E D
I N I T I A L F E E D
A U T O P R E F E E D
S E T U P M E N U
T E S T
F E E D & C U T
P E N U P / D O W N
A D V A N C E D F U N C .
C L E A R B U F F E R
