20
Slide-in Tools
The PT 331S is equipped with a cross crease and/or cross perf function. The
tools are comprised of two pieces. For the crease tools, orientation is not an issue.
Depending on the job requirements the crease can be set to crease up or crease
down. The cross perf tool must always be placed with the rubber crash pad in the
bottom slot and the perf blade tool in the top slot.
Installing the Tools:
Note
: the tools do not have to be in place for the PT 331S to function.
•
Open the side access cover by loosening the top and bottom screws enough
to let the cover swing down.
•
Pull the tools out by gripping the black tool knob. There is no release latch
for the crease tools. The tools should slide in and out, clicking into place
when fully inserted.
•
Store the tools in the tool holder located just under the power plug of the
331S.
Crease Tools Tool Storage Perf Tools
