Booster Operating Instructions
810000082/11139940
9
Eye protection. There is a risk of dust, mounting paste or other foreign objects being
ejected by the airflow and causing serious injury to persons. Therefore safety glasses
must always be worn.
Hazards to others
For the protection of persons located close to the work area, the distance between the point
of use and unaffected third parties must be at least 10 m. If it is not possible to comply with
distance, other methods of separation must be provided.
Tyre
ATTENTION: When the edge of the tyre jumps into the final position, it does so with
a large amount of energy and at high speed.
The general protective measures for workshops and tyre fitting and filling devices should be
applied.
for split rims: please make sure that the locking ring is fitted and fixed correctly.
When filling: Do not fill the tyre beyond the recommended permitted pressure; when filling
use a safety cage for tyres.
Damage: Before starting the filling of the tyre please check it carefully for damage.
Unauthorised use
The booster must not be used for example for blowing away dust.
ATTENTION: Never direct the device at persons, animals or other objects. There is a
risk of severe injuries and property damage.
ATTENTION: The tyres and rims must not be cleaned with highly flammable liquids,
before being filled with the booster.
9.
Maintenance and storage
Maintenance:
The BOOSTER must be checked for damage regularly, in line with the environment in which
it is used. The pressure tank must be subjected to the required statutory inspections. Any
damaged parts must be replaced by original spare parts prior to use. Please take care not to
damage the tapering filling nozzle. Both maintenance and service work must only be done
with the container empty.
Storage:
The BOOSTER must always be stored with the main valve opened and the tapering nozzle
pointing downwards. The best solution is to hang up the BOOSTER on a suitably load-bearing
wall hook in a dry location. For both maintenance work and storage, the ball valve must be
opened slowly, so that can escape slowly out of the container. When doing so the nozzle
should not be held towards the corner of a room or similar, to prevent staring up dirt particles.
