P a g e
|
73
GRP260x Administration Guide
Version 1.0.3.42
Transfer Mode via
Programmable Keys
Configures the transfer mode to use when pressing the "Transfer" MPK.
Choose from
Blind Transfer
,
Attended Transfer
or
New Call, All for
selection.
Enable Transfer via
Non-Transfer
Programmable Keys
MPK with type BLF, Speed dial, etc., will perform as transfer MPK under active
call.
Allow Programmable
Key Configuration
via LCD
Configure to enable Programmable Key configuration via LCD by pressing and
holding MPKs/VPKs.
System Settings Page Definitions
Table 13: System Settings Page Definitions
System Settings
→
Time and Language
Date and Time
NTP Server
Defines the URL or IP address of the NTP server. The phone may obtain the
date and time from the server. The default setting is “pool.ntp.org”.
Secondary NTP
Server
Defines the URL or IP address of the NTP server. The phone may obtain the
date and time from the server. Allow user to configure 2 NTP server domain
names. GRP will loop through all the IP addresses resolved from them.
NTP Update Interval
Time interval for updating time from the NTP server. Valid time value is in
between 5 to 1440 minutes.
The default setting is “1440” minutes.
Enable
Authenticated NTP
Configures whether to enable NTP authentication. If enabled, a cryptographic
signature appended to each network packet. If the key is incorrectly configured,
the phone will refuse to use the time provided by the NTP server.
Allow DHCP Option
42 Override NTP
Server
Defines whether DHCP Option 42 should override NTP server or not. When
enabled, DHCP Option 42 will override the NTP server if it is set up on the
LAN. The default setting is “No”.
Time Zone
Configures the date/time used on the phone according to the specified time
zone. The default setting is “Auto”.
Allow DHCP Option
2 to Override Time
Zone Setting
Allows device to get provisioned for Time Zone from DHCP Option 2 in the local
server. The default setting is enabled.
Self-Defined Time
Zone
This parameter allows the users to define their own time zone, when “Time
Zone” parameter is set to “Self-Defined Time Zone”.
