37
Occupant Safety
Test the CO alarm weekly
TEST the CO alarm at least once EVERY WEEK to make sure that
it is working properly. Stand at arm’s length from the alarm
when testing.
The alarm horn is loud and may be harmful
to your hearing
.
PUSH and HOLD the
TEST/SILENCE
button on the cover until
the red LED flashes. The alarm horn will sound
4 beeps-pause,
4 beeps-pause
. The alarm sequence should last 5-6 seconds.
If the alarm does not test properly:
1. CHECK that the battery is installed correctly.
2. INSTALL a new 9V battery & RE-TEST the CO Alarm.
3. CHECK that the CO Alarm is clean and dust-free.
4.
If it still does not alarm,
REPLACE the CO Alarm immediately.
Battery
REPLACE the battery in your CO alarm when it “chirps” about
once per minute (
the low battery warning
). NEVER disconnect
the battery to silence the CO alarm.
•
When the
low battery warning
sounds, the battery
MUST be replaced to continue your protection.
Maintenance
To keep the CO Alarm in good working order:
•
DO NOT clean with water, solvents, cleaning agents,
bleach, or polish as these may damage the alarm.
• VACUUM the CO Alarm cover once a month,
then
RE-TEST.
• DO NOT paint over the unit. Paint may clog the openings to
the sensing chambers and prevent it from operating properly.
Propane Gas (LP) Alarm
A propane leak detection device is installed for your safety,
because your new RV contains a
propane gas system
and
propane appliances
. Propane gas is heavier than air. During
a leak, propane flows toward and collects in low areas. For this
reason, the propane alarm is located near the floor of the RV.
When the LED on the front glows green, the alarm is active.
•
Individuals with hearing loss or certain medical
problems should consider using warning devices
that provide both audible and visual signals
The sensor may also detect other combustible fumes or va-
pors including; acetone, alcohol, butane and gasoline. These
chemicals can be found in common items such as deodorant,
cologne, perfume, wine, liquor, adhesive, lacquer, kerosene,
most cleaning agents and the propellants of aerosol cans.
TEST Carbon Monoxide
Alarm operation:
after the
RV has been in storage,
before each trip, and
once a week while in use.
• If the CO Alarm ever fails
to test correctly, have it
replaced immediately!
• If the CO Alarm is NOT
working properly, it
cannot
alert you to a
problem.
• Failure to test units used
in RV’s as described may
remove your protection.
The Test/Silence button
is the only proper way to
test the CO Alarm.
NEVER test the CO alarm
with vehicle exhaust !
Exhaust may cause
permanent damage and
voids your warranty.
WARNING
DO NOT try fixing the
Alarm yourself, this will
void your warranty
!
If the CO Alarm is NOT
operating properly, and
it is still under warranty,
please see “How to Obtain
Warranty Service” in the
Limited Warranty. Install a
new CO Alarm immediately.
WARNING
DO NOT spray cleaning
chemicals or insect sprays
directly on or near the CO
Alarm.
DO NOT paint over the CO
Alarm. Doing so may cause
permanent damage.
WARNING
Содержание Imagine 2021
