Universal Slicer Master Classic C 6 / Classic C 6
20
EN
Returning the packing to the ma-
terials circuit saves raw materials
and reduces the accumulation of
waste. Dispose of packing material
that is no longer needed at a col-
lection point for the »Green Point«
recycling system.
important!
►
If possible, save the original
packing during the unit's warran-
ty period to be able to properly
pack the unit in case of a war-
ranty claim.
Requirements for the in-
stallation location
For safe and flawless operation of
the unit, the place of location must
meet these prerequisites:
■
The unit must be set up on a
firm, flat, level and non-slip base
that has sufficient load bearing
capacity.
■
Select the place of location so
that children cannot reach the
sharp blade in the unit.
Electric connection
Follow these instructions about the
electrical connection for safe and
flawless operation of the unit:
■
Before connecting the unit, com-
pare the connection information
(voltage and frequency) on the
rating plate with those of your
electrical network. This informa-
tion must match to avoid dam-
age to the unit. If in doubt, ask
your electrician.
■
Make sure that the connecting
cable is not damaged. Do not
conduct it over hot surfaces or
sharp edges.
■
The connector cable must not be
pulled tight.
■
The electrical safety of the unit
is only ensured if it is connected
to a properly installed protective
conductor system. Operation
on a socket without a protec-
tive conductor is prohibited. If in
doubt, have the building instal-
lation checked by an electrician.
The manufacturer does not as-
sume any responsibility for dam-
ages caused by a missing or in-
terrupted protective conductor.
