3 6 0 E
X P R E S S
8–15
Bow Thruster Charger
This single bank battery charger is located beneath the aft starboard helm seat just forward of
the bait station. The generator must be running or the dockside power must be connected with
load group 1 energized for the charger to work. To activate the charger, turn the AC panel
breaker switch to the on position. The charger has a built-in isolator that senses the charging
needs of the bow thruster battery and delivers charge accordingly (maximum output of 6
amps). There is a 9A in-line fuse in the positive charging lead to the battery. If the charger
appears to be operating normally but the battery does not recharge, check this fuse and replace
as necessary. At the point that the battery is nearly fully restored, the charger will
automatically reduce the current being sent to a maintenance level. See this charger’s
Operation Manual in your Owner’s Packet for further information on the charger. See
“12 Volt
DC Elementary Diagram” on page 8–59
and
“120 Volt AC Electrical Diagram” on page 8–
62
for wiring detail.
Cockpit Coolers
The aft fishbox and port cockpit insulated coolers are also refrigerated. The cockpit coolers
switch on the AC panel must be on to cool these boxes. It is not required to have the air/cooler
pump switch on and the air condition seacock open to cool these boxes, but it is
recommended. The raw water moving through the system will allow the refrigeration unit to
cool the boxes more efficiently. If you choose to turn the air/cooler pump on, ensure the air
condition seacock is open. Refer to
“Air Condition & Cockpit Coolers One-Line Diagram”
on page 8–54
for wiring detail.
These boxes may be used as freezers or refrigerators by designating the set point temperature
for each box. The set points for each box are set using the digital temperature switches in the
cooler control panel located in the galley area near the cabin door. To establish the set point,
first press set — SP text will appear on the display. Press set again — the value will appear on
the display. Change the temperature set point to the desired value using the up and down
arrows. Press set when the desired set point is displayed to enter this value. Press set and down
simultaneously to exit programming or wait one minute and the switch will exit programming
mode automatically. Please reference the owner’s manual for this system included in the
owner’s packet for more detailed information.
Microwave
The dockside power must be connected or the generator must be operating with load group 1
energized for the microwave to function. A foam block has been provided to protect the glass
platter inside the microwave when the boat is in motion. Ensure this block is in place when the
microwave is not in use — remove before operation. Refer to the microwave operation and
maintenance manual in your owner’s packet for specific instructions on the safe and proper
use of the microwave.
Outlets
Current is provided to all outlets by the generator or dockside power. Each outlet is ground
fault protected and switched individually at the AC panel. These outlets will operate any
standard household appliance (i.e. blender, coffee maker). However, the total combined
wattage, in addition to other AC accessories, must not overload the boat’s generator output.