Grady-White Boats Freedom 325, Руководство пользователя, Страница: 63 / 80

8-11
Chapter 8: Freedom 325
Livewell - Raw Water
To operate the livewell, open the seacock located in the aft bilge using the remote seacock arm
labeled livewell; the livewell pump is screwed directly into this seacock. Plug the drain in the bottom
of the livewell and place the livewell switch on the helm switch panel in the “on” position. Water will
enter through a plenum along the side of the livewell and be distributed through a series of holes
arranged vertically along the plenum. The water will rise until it reaches the overflow drain at the
top of the plenum, and then drain overboard.
N OT I C E
If the livewell seacock is left open and the pump is not on, the boat’s forward motion through
the water will gradually fill the box. To prevent this inadvertent filling, close the seacock when
the livewell is not in use.
Under certain conditions, placing the outboard engine(s) in reverse will ventilate the water
under the boat and create an air lock in the livewell pump. To prevent this situation from
occurring, it is recommended the livewell be turned off prior to any high RPM or continuous
reverse operation. If the livewell pump becomes air-locked, correct this situation by turning
the pump off for 20 seconds.
Lounge Seats
The lounge seats include extendable seat bottoms. This allows for the seats to be adjusted to
provide more seating area for passengers when extended or maximize cockpit space when retracted.
The starboard lounge seat switch is on the inboard facing wall forward of the seat. The port sliding
seat switch is in front of the forward facing companion seat in the port deckwing insert.
C A U T I O N
To prevent damage to the deck floor, do not activate the sliding seat bottom while a passenger
is on the seat.
Main Circuit Breaker
There is a 50A circuit breaker located in the battery select switch box near the transom door.
This is the main breaker protecting the wiring supplying power to the positive bus bar at the helm. If
this breaker is tripped, the yellow trip lever will be positioned horizontal. Slide the trip lever back to
a vertical position to reset it.