Grady-White Boats Freedom 307, Руководство пользователя

Страница: 66 / 91

F
R E E D O M
3 0 7
8–14
L
IVEWELL
- R
AW
W
ATER
To operate the raw water livewell, open the seacock with the livewell I.D. tag located in the
port aft bilge. The livewell pump is threaded directly into this seacock. The livewell switch at the
helm should be in the “on” position. Place the livewell standpipe in the drain located at the bottom
of the livewell. Screw it down until the black flange makes contact with the flange on the drain
fitting. Water will enter through a plenum along the side of the livewell and be distributed through
a series of holes arranged vertically along the plenum. The water will rise to a depth even with the
strainer on the standpipe and drain overboard. To evacuate debris and bait waste from the bottom
of the box while the livewell is in operation, unscrew the standpipe approximately three turns to
expose two 3/8” holes located in the threads of the standpipe base. This will allow a small amount
of water to escape through these holes and remove any waste that has settled in the bottom of the
livewell. See
“Livewell/Raw Water Washdown Layout” on page 8–24 for a layout diagram.
O
UTRIGGERS
The outriggers spread the fishing lines being trolled from your boat and decrease the chance
of entanglement.
• Advantages
Advantages include offering bait throughout a larger area behind the boat, placing bait out of
the wake zone, automatic drop back following strikes (which allows for fish to completely
accept bait), and a reduction in unnecessary twisting action characteristic of artificial bait.
• Instructions
For installation and use, reference the sheet included in your Owner’s Packet.
• Care And Maintenance
1. Outriggers should be washed with freshwater, mild soap, and a soft cloth. Never use
abrasive cleaners on outriggers.
2. A periodic waxing is suggested if your outriggers are exposed to salt water. The wax will
provide a protective coating and seal the pores of the metal. A non-abrasive high quality
marine or automotive wax is recommended. Before storage, clean and wax the outriggers.
3. During assembly, grease all threads, bolts, and tubes where one section is inserted into
another. Disassemble and regrease all applicable surfaces on an annual basis.
N O T I C E
If the livewell seacock is left open and the pump is not on, the boat’s forward motion through the
water will gradually fill the box. To prevent this inadvertent filling, close the seacock when the
livewell is not in use.
Under certain conditions, placing the outboard engine(s) in reverse will ventilate the water under
the boat and create an air lock in the livewell pump. To prevent this situation from occurring, it is
recommended the livewell be turned off prior to any high RPM or continuous reverse operation.
If the livewell pump becomes air-locked, correct this situation by turning the pump off for 20
seconds.