Grady-White Boats Freedom 285, Руководство пользователя, Страница: 58 / 85

F
R E E D O M
2 8 5
8–6
H
ARDTOP
Do not use the hardtop for storing heavy or large items such as a raft. The frame for the top is
designed for continual use with antennas, radar, and outriggers. The additional weight caused by
larger items such as a raft may cause damage to the frame structure.
M
AIN
C
IRCUIT
B
REAKER
There is a 50 amp circuit breaker located in the battery select switch box near the transom
door. This is the main breaker protecting the wiring supplying power to the positive bus bar. If this
breaker is tripped, the yellow trip lever will be exposed. Sliding the trip lever back to a horizontal
position will reset.
P
ORTABLE
H
EAD
O
PERATION
1. The upper freshwater reservoir must be filled with water prior to use.
2. Compress the bellows pump located on the left corner of the toilet a few times to add water
to the bowl.
3. Flush the toilet by pulling the slide valve handle out (located on the front of the toilet).
4. Compress the bellows pump until the bowl is rinsed.
5. Close the slide valve handle by pushing it in fully.
R
IGGING
C
OMPARTMENT
The rigging compartment is located aft of the fuel tank compartment. This enclosure is used
for rigging ignition protected accessories and for better passage to the rigging components located
aft of this compartment.
S
EACOCKS
Ball valve seacocks are installed on the thru hulls for the livewell, washdown, air/cooler
pumps, generator systems and some head features. It is necessary for the seacocks to be in the
“open” position for operation. The “open” position is identified by the orientation of the handle. If
the handle is in line or parallel to the body of the valve, the seacock is in the “open” position. If
the handle is perpendicular to the body of the valve, the seacock is in the “closed” position. For
seacocks with remote arms installed, the “open” position can be obtained by pulling up on the
remote arm attached to the seacock handles. Pushing down on the remote arm closes the seacock.
N O T I C E
The rigging hatch and mounting screws must be sealed with silicone sealer after rigging is
complete. If the lid is removed, it must be resealed to insure watertight integrity.
C A U T I O N
All seacocks should be in the “closed” position if not in use or if the boat is unattended to prevent
the taking on of water if a plumbing component fails.
!