E
X P R E S S
3 7 0
8–3
• Spreader Lights
This switch, located on the cockpit switch panel, activates the hardtop spreader lights. A
circuit breaker located beside this switch provides over-current protection for this circuit.
• Underwater Lights (optional)
This switch activates the underwater lights. A circuit breaker located above this switch
provides over-current protection for this circuit.
• Washer
This momentary switch operates the windshield washer. Depress and hold the top of the
switch until a sufficient amount of water is sprayed onto the windshield. A circuit breaker
located above this switch provides over-current protection for this circuit.
• Windlass
This switch operates the anchor windlass. Depress the top of the switch to raise the windlass
and the bottom of the switch to lower the windlass.
• Windshield Vent
This momentary switch activates the actuator which opens and closes the center vent in the
windshield. A circuit breaker located above this switch provides over-current protection for
this circuit.
• Wiper
This switch powers the windshield wipers. A circuit breaker located above this switch
provides over-current protection for this circuit.
• Accessory
Switches and breakers labeled “ACC” are blank. They may be used for non-factory installed
accessories. A circuit breaker located above this switch provides over-current protection for
this circuit. See
“370 DC Accessory Wiring Color - Fuse/Breaker” on page 6–10
for
recommended breaker amperages. Switch labels are available from your dealer for non-
factory installed options.
Other Switches
• Trim/Tilt
The trim/tilt switch is located on the throttle control. Trim changes the angle of thrust of the
engine (reference
). Tilt raises the drive unit for trailering.
• Trim Tab
These switches control the hydraulic trim tabs used for adjusting the attitude of the boat. See
for more details.
N O T I C E
Use anti-corrosion spray on the back of panels and on exposed wires to prevent the rust or
corrosion that could lead to an electrical system failure.
N O T I C E
Use anti-corrosion spray on the back of panels and on exposed wires to prevent the rust of
corrosion that could lead to an electrical system failure.
Содержание Express 370
