Section 4 - Attachments
4-6
80804002
3. Move adapter toward "bucket close" position until
outer end of adapter contacts bucket. Ensure
proper alignment and continue to close until
adapter contacts stops
(1)
.
4. Only use the nuts to move wedge bolts forward to
position wedge between adapter and bucket bar.
Do not use fingers to slide wedges forward or to
keep wedges from turning when tightening nuts.
Be certain wedge surfaces are flush between
adapter and bar and tighten fully. Jog tool control a
few times and re-tighten. Check often to be sure
bolts remain tight.
CRUSH HAZARD.
Keep boom in fully extended
position while installing bucket. Stay clear until bucket
adapter has been fitted to bucket as shown in step 3.
Digging with a loose or improperly fitted bucket may cause excessive wear, shear
adapter bolts or cause loss of bucket.
OAC0790
1
OAC0800
WARNING
OW0021
Содержание XL3100IV
