Setup
3A2776K
17
Setup
Location
Select a location that complies with the approval rating
for your model. For approval rating, see
on page
The location must have the required power and air
supply to set up your sprayer. See
, page 98, for Air Consumption and
Power Requirements. Maintain access from all sides.
Unboxing
The machine is shipped on two separate pallets, one
with the XM PFP and one with the two feed modules.
Each pallet is wrapped in heavy cardboard with a lid
secured with straps. Cut the lid straps then remove the
lids and cardboard.
Ratio Configuration
Proportioners leave the factory set up for materials
which are higher volume and/or viscosity on the “A”
side, and lower volume and/or viscosity on the “B” side.
1:1 mix ratio machines will normally change the “B” side
circulation return hose from 3/8 in. to 1/2 in. ID to
balance the recirculation speeds.
1:1 mis ratio machines also use outlet hose bundles
which are 3/4 in. on both sides. The outlet fittings on the
machine and the inlet fittings on the mix manifold must
be changed on the “B” side from 1/2 in. to 3/4 in.
1:1 Ratio Adapter Kit 24X461 is provided with your
machine. Install the kit, if necessary, before screwing
the modules together.
Configuration Options
The system can be laid out two ways:
•
Side by side: where the feed modules are on either
side of the system module
•
Front to back: where the feed modules are behind
the system module
F
IG
. 9
Front to Back Configuration
Side by Side Configuration
WLE
