Repair
26
3A8047B
Replace Radar Level Sensor
NOTE:
Order radar level sensor kit 26C587. See
on page 45 for kit contents.
NOTE:
Tank level sensors changed in 2014. The old
sensors were red. The new sensors are blue. The blue
sensors can be used as direct replacements for the red
sensors.
1. With the tank empty, close the tank air supply ball
valve then open the valve on the tank lid to
de-pressurize the tank.
2. Disconnect cable at the bottom of the feed module.
Always use the new cable supplied with the sensor.
It has different connections than the old sensor.
3. Disconnect 3/4 in. union that holds the level sensor
on top of the tank.
4. Pull the old sensor straight up out of the tank.
5. Remove plugs from new sensor and discard plugs.
Move fittings from old sensor to new sensor.
6. If the sensor rod was removed for shipping, apply
blue thread-lock to the threads in the end of the
rod.
7. Feed the rod into the sensor head and screw the
threaded end into the sensor head.
8. Use a wrench to hold the 3/8 in. flats on the sensor
rod.
9. Tighten to approximately 25 - 30 in-lb (2.8 - 3.4
N•m). Do not over-tighten.
10. Reconnect sensor cable.
11. See
Set Up a New Radar Level Sensor
, page 27.
WLD
Tank Air
Supply Ball
Valve location
(on other side
of panel)
Valve
Содержание XM PFP 273231
Страница 38: ...Parts 38 3A8047B Base System 262878 page 2 of 5 Set air regulator to 80 psi 550 kPa 5 5 bar WL D D F E...
Страница 46: ...Parts 46 3A8047B WL D...
Страница 64: ...Dimensions 64 3A8047B Dimensions WL E WL D FP LQ FP LQ FP LQ FP LQ FP LQ FP LQ FP LQ FP LQ FP LQ...
Страница 67: ...Notes 3A8047B 67 Notes...
