3.3
Remove Shipping Brackets
To protect the equipment, the robot is shipped with a locking mechanism for each axis:
3.4
Attach the PC
The PC mounting bracket is attached to the robot. Insert the PC mounting pins straight
into the bracket and push straight down.
Figure 4: Push Mounting Pins In and Down
Figure 5: PC Mounting Bracket on Robot
X-AXIS SHIPPING BRACKET
1 SCREW (SHBS M4 X 8)
2 SCREWS (SHBS M3 X 8)
Y-AXIS SHIPPING BRACKET
1 SCREW (SHBS M4 X 8)
2 SCREWS (SHBS M3 X 8)
Z-AXIS LOCKING SCREW
+ SPACER
X-AXIS
REMOVE LOCKING
BRACKET SCREWS,
REMOVE BRACKET.
APPLY THREAD
LOCKING FLUID TO
ALL SCREWS
AND RE-INSTALL ON
THE ROBOT.
Z-AXIS
REMOVE SCREW
AND SPACER;
STORE WITH THE
BRACKETS.
Y-AXIS
REMOVE SHIPPING
BRACKET SCREWS,
REMOVE BRACKET.
STORE THIS SCREW
WITH THE BRACKET.
APPLY THREAD
LOCKING FLUID TO
THESE TWO
SCREWS AND
RE-INSTALL ON
ROBOT.
3A5913B
UniXact Automated Jet Dispense System Installation
Page 9 of 18
