4.
Power and Test Components
4.1
Turn On Power to System Components
Note: Turn on power in the order listed.
Advanjet Controller:
Use the main power switch on the controller front panel.
1.
Monitor:
Use the main power button on the front of the monitor.
2.
Keyboard and Mouse
are battery powered and have individual power switches.
3.
Wireless communication is enabled when PC is powered on.
Robot:
Use the Main power switch on the robot rear panel.
4.
Note: After turning on the Robot power, wait for the beep before booting the PC
and running the Dispense Pro Software. This can take up to 40 seconds.
PC:
Use the power button on the PC front
5.
4.2
Test Pneumatic Connections
1. Use the Jet Pressure
Regulator to set Jet
Pressure to 40 psi
(0.28 MPa).
2. Press the
Trigger
button and listen for the
air bursts when the
valve closes and opens.
3. Tap
Fluid Pressure
on the Controller touch
screen. When the field
shows a red border, tap
Keypad
and set Fluid
Pressure to 20 psi
(0.14 MPa).
4. Turn the
Fluid Air
switch ON. Listen for air
flowing from the fluid
receiver head.
3A5913B
UniXact Automated Jet Dispense System Installation
Page 13 of 18
