Graco ToughTek SL340e, Инструкция по эксплуатации

Страница: 8 / 34

Component Identification
8 3A7382B
Fluid Drain/Purge Valve
Open the drain/purge valve (C) to relieve pressure if
pump or hose pack-out occurs, or to relieve pressure
inside the hose. Close valve when spraying.
Motor Power Switch
The motor power switch (S) must be in the ON position
for the sprayer to pump material.
Motor Power Switch Settings:
To avoid injury from splashing fluid, never open a
cam-lock hose or applicator fitting while there is
pressure in the fluid line. Follow the
Pressure Relief
Procedure
on page 15.
NOTICE
To prevent material hardening in fluid drain/purge
valve, flush the valve after every time it is used. Failure
to flush prior to material curing in the system will result
in damage to the system and may require replacement
of all system parts in contact with the material. Follow
the
Flush
procedure on page 11.
WLD
&
OFF Power is disconnected. The motor will not run.
ON
The motor will run continuously at a speed
determined by the flow adjustment knob.
WLD
S