Troubleshooting
3A1450B
11
Troubleshooting
Problem
Cause
Solution
Pump output low on both strokes.
Restricted air supply lines.
Clear any obstructions; be sure all shutoff
valves are open; increase pressure, but
do not exceed maximum working pres-
sure.
Exhausted fluid supply.
Refill and reprime pump.
Clogged fluid outlet line, valves, etc.
Clear.
Worn piston packing.
Replace. See lower manual.
Pump output low on only one stroke.
Held open or worn ball check valves.
Check and repair.
Worn piston packings.
Replace. See lower manual.
No output.
Improperly installed ball check valves.
Check and repair.
Pump operates erratically.
Exhausted fluid supply.
Refill and reprime pump.
Held open or worn ball check valves.
Check and repair.
Worn piston packing.
Replace. See lower manual.
Pump will not operate.
Restricted air supply lines.
Clear any obstructions; be sure all shut
off valves are open; increase pressure,
but do not exceed maximum working
pressure.
Exhausted fluid supply.
Refill and reprime pump.
Clogged fluid outlet line, valves, etc.
Clear.
Damaged air motor.
See air motor manual.
Fluid dried on piston rod.
Disassemble and clean pump. See lower
manual. In future, stop pump at bottom of
stroke.
TSL pump not pumping TSL fluid.
Plugged manifold.
Clear the manifold. Verify that the mani-
fold is clear by blowing compressed air
through the opening.
Plugged check valves.
Clear obstruction in check valves.
Plugged inlet strainer.
Clear strainer mesh.
Damaged TSL pump piston.
Replace TSL pump piston.
Содержание President 24H627
Страница 14: ...Repair 14 3A1450B...
