Graco GrindLazer 25M842, Операция - Ремонт - Запчасти

Страница: 19 / 68

Operation
3A5578C 19
DCS Instructions
Each time the DCS Control is turned on, the DCS actua-
tor will travel to the Home position.
Once the DCS Control finds Home, ensure the current
model is selected as well as your desired language and
units. See
Menu Screens , page 13, for instructions on
changing these settings.
Set Zero Point:
Lower the Depth Control Wheels to the surface by using
the Drum Engage Lever to unlatch the drum housing
from the “up” position. With the engine on, lower the
drum by pressing the Down Arrow Button until you hear
the cutters make contact with the pavement surface.
Hold down the Zero Button for 2 seconds. Your Zero
Point has now been saved.
NOTE: The Cut Depth Target is based off of the Zero
Point. Re-program the Zero Point if the drum is changed
or worn.
Set Cut Depth Target:
Quick press the Zero Button to take the drum to the
pavement surface. Set the Cut Depth Target by:
1. Quick pressing the Down Arrow Button as many
times as needed to achieve your target. Then long
press the Cut Depth Button to save your target.
NOTE: This method will lower the cutting drum into
the pavement surface as you set your cut depth.
OR
2. From the Zero Point, long press the Cut Depth But-
ton until a new screen pops up. Use the Down
Arrow Button to enter your Cut Depth Target. Then
long press the Cut Depth Button to save your target
and return to the Run Screen.
NOTE: This method will keep the cutting drum sta-
tionary as you set your Cut Depth Target.