Graco Geo Blaster GB1200, Операция и комплектующие

Страница: 10 / 54

Pressure Relief Procedure
10 3A4167C
Pressure Relief Procedure
1. Close the abrasive ball valve (P).
2. Close the compressor supply air valve, then turn the
compressor off.
3. Engage the blast control switch to relieve pressure
in the system.
4. Verify that the supply air pressure gauge (L) reads
0 psi. Then disconnect the air inlet hose from the
system.
5. Turn selector valve (K) to the OFF position.
6. Open pot dump valve (N) to depressurize the blast
pot. Ensure pot pressure gauge (G) and supply air
pressure gauge (L) read 0 psi.
Follow the Pressure Relief Procedure
whenever you see this symbol.
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury
from pressurized fluid, such as splashing fluid, follow
the Pressure Relief Procedure when instructed.
P
L
K
N