Graco E-Flo SP, Инструкция по установке и каталог запасных частей

Страница: 30 / 46

Kits and Accessories
30 3A6586D
9. Connect the CAN cable included in the kit to either
port 1 or port 2 (whichever is available) on the
driver. See
Figure 23
.
10. Connect the other end of the CAN cable to either
CAN port 1 or 2 on the CGM. See
Figure 20
. It can
be connected to either port.
NOTE:
Longer CAN cables, if required, are available
from Graco. See
CAN cables
on page
32
.
11. Connect the Ethernet, DeviceNet, or PROFIBUS
cable to the fieldbus connection on the CGM as
applicable. See
Figure 24
.
12. Connect the other end of the cable to the fieldbus
device.
13. Refer to the Graco Control Architecture Module Pro-
gramming manual for step-by-step instructions on
how to update the software version of GCA mod-
ules. See
Related Manuals
on page
2
.
14. Refer to the E-Flo SP Software Instructions manual
for details regarding the fieldbus pinout setup and to
perform the setup procedure to configure the field-
bus. See
Related Manuals
on page
2
.
Inlet Pressure Sensor Kit,
24Y245
Attach the 5-pin connector to port 6 on the driver. Insert
the o-ring over the other end and connect the adapter
fitting. Attach the assembled pressure sensor to the fluid
input stream based on the configuration of your system.
F
IG
. 23: Driver Port Locations
F
IG
. 24: CGM Fieldbus Connection
Port 1 Port 2
Port 6
Fieldbus
Connection
Part Description Qty
16U440 ADAPTER, fitting, pressure sensor
1
15M669 SENSOR, pressure, fluid outlet
1
119348 PACKING, o-ring
1