Service
308491U
13
7. Install the screws (24).
8.
Position the trigger (25) on the gun body. Insert the
pivot pin (28) into the top hole (A) and secure with
the screw (29) on the other side. Place an e-clip (27)
on one end of the trigger pin (18). Slide the pin
through lower trigger holes and through the slot (B)
in the spring guide (16) (turn the spring guide
to
align, as needed). Install the other e-clip (27).
9.
If it was removed, install the spring tension screw
(21) at the rear of the gun. Then, turn the screw in
until it stops.
Test the Gun Before Regular
Use
1.
Lock the gun trigger safety. Connect a hose to the
gun. Start and prime the pump.
2. Release the gun trigger safety. Trigger the gun into
a waste container. Release the trigger to be sure
the gun immediately stops spraying and that there
are no leaks.
3. If the gun has a diffuser, check the diffuser using the
procedure on page 9.
4. Install the tip guard (30) before regular use.
24
ti04733b
ti04732a
29
28
27
18
25
A
B,16
Ref.
Action
Turn in until screw stops
1
21
1
ti03980a
ti03965c
30
