Installation
6
3A5453D
Install the Agitator
1. Due to variability in drum heights, the lowest set of
blades may contact the bottom of the drum. To
move the blades, loosen the setscrew on the hub
and slide the assembly up or down to the desired
position. The setscrew must always remain on the
top, with the blades hanging down, so the blades
will pass into and out of the bung hole.
NOTE:
For many drums, the ideal height for the bottom
blade is 0.5 in.-1.0 in. (13 mm-25 mm) above the shaft.
The ideal height may vary based on the drum.
NOTE:
Ensure at least 1 in. (25 mm) of clearance
between the shaft and the base of the container.
2. To install the agitator on the container cover, drop
the folding blade sections through the drum bung
hole, then screw the bung adapter into the bung
hole. See
NOTE:
During installation, if resistance is felt from the
blades contacting the container bottom, continue to
gently screw the bung adapter into the drum. This
motion will cause the blades to spin outward. If the
resistance does not change, verify that the shaft is not
contacting the base of the container.
3. Position the air motor so the air line can be attached
easily to the needle valve 1/8 npt inlet, without
obstructing any other system components.
4. Attach an air line quick disconnect valve or ball
valve for main air shutoff. Order coupler (part
208536) and fitting (part 169969).
5. Attach the air line between the needle valve 1/8 npt
inlet and the 1/8 npt air supply manifold
outlet.
To prevent fire and explosion from sparks due to
contact:
•
Always maintain a minimum of 1 in. (25.4 mm)
clearance between agitator parts and container
sides, while stationary or rotating.
•
The blades are allowed to come into contact with
the base of the container when the agitator is not
operating and the blades are at rest. Use only
non-flammable or water-based materials, or
materials having a flash point lower than 140° F
(60° C).
F
IG
. 3: Adjust Location of Hub/Blade Assemblies
WLE
NOTICE
Keep the agitator tightly mounted to the drum bung to
prevent damage to the threads from vibration.
