Graco 25D614, Инструкция по эксплуатации

Страница: 9 / 16

Installation
3A5541D 9
Update ADM Software
1. Shut down system. See your Reactor operation
manual for shutdown instructions.
2. Loosen the set screw on the ADM mounting bracket.
Remove the ADM from the bracket.
3. Remove the token access panel on the back of the
ADM.
4. Insert and press the software upgrade token firmly
into the slot.
NOTE: There is no preferred orientation of the token.
5. Turn on the system power.
NOTE: When the ADM display turns on, you may see
the following screens:
6. Remove the software update token.
7. Replace the token access panel.
8. Remount the ADM. Tighten the set screw fully.
9. Press to continue to the operation screen.
NOTICE
A status is shown while software is updating to
indicate progress. To prevent corrupting the software
load, do not remove the token until the status screen
disappears.
First:
Software is checking which
modules will take the
available updates.
Second:
Status of the update with
approximate time until
completion.
Third:
Updates are complete.
Icon indicates update
success/failure. See the
following table.
Icon Description
Update successful.
Update unsuccessful.
Update complete, no changes necessary.
Modules were updated or didn’t require
an update; however, one or more mod-
ules need to be updated manually with a
token.