Graco 24V016, Запасные части

Страница: 14 / 26

Repair
14 333233D
6. Remove grounding screw (GS) and disconnect
green grounding wire coming out of fan cord grip
(C1) attached to driver (not the junction box).
7. Loosen fan cord grip (C1) attached to driver and pull
out fan wires.
8. Remove screws that attach fan assembly to driver
and pull up on end farthest from junction box. Slide
assembly toward junction box to remove.
9. Install new fan assembly. To reattach the fan assem-
bly, slide cover into slots for tabs located on junction
box side and gently push down far end. Apply
thread locker and use supplied fasteners and wash-
ers. Torque to 15 - 20 ft-lb (20 - 27 N•m).
10. Route wires through fan cord grip (C1) attached to
driver (not the junction box (S)).
11. Reattach the ground wire to the grounding screw.
Tighten ground screw. See F
IG
. 11.
12. Use a ferrule to connect each fan wire to one of two
wires coming out of the motor grommet. Then attach
one wire set into the disconnect box location 1L1
and the other wire into location 3L2. See F
IG
. 11.
13. Gently tuck wires back into junction box (S) around
disconnect block (J) and reinstall junction box cover
(G). Replace two screws (53) and washers, then
tighten. See F
IG
. 9, page 13.
NOTE: Make sure no wires get pinched during
installation.
14. Tighten cord grip attached directly to driver
assembly.
F
IG
. 11: Grounding Screw
F
IG
. 12: Remove Fan Wires
F
IG
. 13: Fan Assembly Removal
WLE
GS
WLD
WLD
F
IG
. 14: Fan Assembly Installation
NOTICE
If wires get pinched when the screws are tightened,
damage will occur. Make sure all wires are routed
correctly before installation.
WLE
C1
WLD
/
/
/
7
7
7