ELECTRONIC THERMOSTAT
CIRCULATED AIR
MODEL 2362E
PARTS
Unpack the incubator from box. Check
for the components listed below.
Top with heat element, fan,
pilot light, thermostat, &
vent plugs installed.
Hova-Bator Bottom
Wire Floor
Plastic Liner
Owl Clips x 4
HOVA-BATOR
Owl Clip
Owl Clip
Slide clips over
wire fl
oor & under
plastic liner
Notch
Unpack the incubator from the box
and set aside the thermometer
and wire floor. Remove the top
half from the bottom.
Attach
Wire
Floor
to
Plastic Liner
with
Owl
Clips
then place fl oor and liner in
Hova-Bator Bottom
. Arrange the
plastic floor as shown using the
water troughs and turner power
cord notch as reference. In most
climates, fi ll trough #1 (highlighted
in yellow) with water. Surface area,
not depth, determines humidity;
refi ll trough as necessary to prevent
it from drying out.
NOTICE: Humidity troughs should be fi lled with cool tap water. Careful to avoid spilling
excess water outside of trough as it will eff ect humidity. Humidity should be between
45 and 55% for SETTING and 55 to 65% for HATCHING. Setting the humidity above
65% is not recommended as it may cause condensation to form on the windows and
can decrease hatch percentage.
Plug the cord set into the appropriate wall socket. The fan should then run and the
small heat indicator light on the thermostat box should be lit. Allow the incubator
to warm up for one hour.
When the light begins blinking regularly, the incubator
is nearing its set point.
SETUP
1825 Thermometer
MADE IN USA