Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
USER’S GUIDE
V: 775-01
C353B
Clock Radio with Dual Alarm
FCC Warnings
Introduction and Setup
Plug the built in AC power cord into an AC
power outlet to power the dock.
Power
The battery backup is intended for short
power outages only. The clock radio’s primary
functions cannot run off of the battery backup
alone.
Requires 2, AAA-size, batteries (not included)
Battery Backup
PM Indicator
Lights when the time
is in the PM.
Dimmer
Press to dim the
display.
Tuning/Min/Hour
Press to tune the
radio.
Press to adjust the
minute or hour when
setting the clock or
alarm.
Clock/Mem
In Off mode, press
and hold to begin
setting the time.
In radio mode, press
to cycle through
preset stations.
LED Display
Power/Source/AL Off
Press to turn the unit on.
Press and hold to turn
off the radio.
Press to turn off the alarm.
Snooze/Sleep
Press to snooze the
alarm after it sounds.
Press repeatedly to
set the sleep timer.
Alarm 1 Buzzer/
Radio Indicator
Lights when the
alarm 1 is on and set
to buzzer
or radio.
Alarm 2 Buzzer/
Radio Indicator
Lights when the
alarm 2 is on and set
to buzzer
or radio.
Volume/AL1/AL2
Press to adjust the
volume.
Press to begin setting
Alarm 1 or Alarm 2.
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com Customer Service: 1-888-999-4215
Email Support: [email protected], Email Parts: [email protected]
Copyright © 2012 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners.
Specifications are subject to change without notice.
