Base Unit
Search button
Press to search for the Tag unit.
Model Name
708AA
Base Unit
Tag Unit
1 pc
Batteries
CR2032x2
User manual
Strap
Hook
1
1
Base Unit
Tag Unit
1 pc
Tag Unit
Page 1
Page 2
Model Name
Function
Search Range
Alarm Triggered
Base Unit / Tag Unit
Base (M08AM)x1
Battery Type
CR2032
Battery Life Time on Standby
Over 45 days (8 hrs/day)
Beep Audible Level (at 10 cm / 3.9 inches)
Base unit : 95 db, Tag unit : 102db
Dimension (L/W/H)
Bike Guard 708AA
Alert & Search
0~300m/984ft
1
2
3
Speaker
Battery cover
Sound output
Bike Guard 708AA USER MANUAL
Bicycles are stolen everywhere and every day no matter they are with or without locks. To protect your bicycle
from being stolen, our Digital RF wireless bicycle alarm system can be your best solution. Once the bike theft
happens, the Bike-Alarm will sound loud beeps to scare the thief away and the Beeper will also immediately
activate an emergency alarm to warn you to check the bicycle and take the necessary actions urgently.
Therefore, with Bike Guard 708AA armed on the bicycle, whenever you want to take a short break in the cycling
journey, there is no need for you to worry about parking your bike nearby.
1
2
3
4
5
6
Ring attachment
Speaker
Connecting status
Power switch
Battery cover
Power ON/OFF
Show the signal synchronous status between Base and Tag unit
Sound output
Tag (S07B)x1
Vibration Sensor
Bike Guard 708AA USER MANUAL
Front
Back
1
2
3
Base unit :
61.5x36x11.6mm
(
2.42x1.42x0.46inch
)
Tag unit : 38x120x6.2mm(1.5x4.72x0.24inch)
Front
Back
1
2
3
4
5
6
INTRODUCTION
1
Product Description
Product Description
Package Contents
How to apply/wear the Base and Tag units.
GETTING STARTED (Out-of-range Alert)
2
This section shows how to quickly setup and trigger an alert condition.
1. Insert the batteries into the Base unit and the Tag unit.
a)
Slide
out
(remove)
the battery covers on the Base and Tag Units.
b) Insert batteries (included) with the “+” mark facing upward in the battery compartments.
c) Replace the battery compartment covers on both units.
2. Make sure that the Base and Tag units are in close proximity.
3. Turn ON the Power switch on the Base units. The base units will establish a link and begin to
blink synchronously .
4. Shock the Tag unit and the base will beep.
5. Congratulations, now you are ready to p
ut the Tag unit underneath the bottle cage on a bike
(in
case the alarm is triggeved while installation).
c
b
a
On/Off switch
b
a
c
Base Unit
Tag Unit
Alert
3
A sensor is bulit-in to detect the vibration, while someone is trying to move your bike, the Bike
Guard will alert you in 3 seconds. The Base&Tag unit will alarm for 5 seconds and repeat alarm
until vibration is stop.
Disarm Alarm:
Under standby mode, turn OFF the Master unit within 1 meters from your bicycle, the Tag unit will
sound "Di-du" to approval disarm. When you hear "Di-du", you have disarmed Bike Guard.
Screw Hole
Beep Beep...
Beep Beep...
