600 Built Under Oven Unit Assembly
Components
Ref. No.
Item
Quantity
Ref. No.
Item
Quantity
Ref. No.
Item
Quantity
Tools Required
1
2
Assembly Instructions
3
Without Drawer
4
With Drawer
Important Information -
True Handleless Kitchens Installers
: See Note Above
TH
154085
10
154068
6
10
154004
2
151999
152401
4
152418
4
152402
2
5mm
Drill
Spirit Level
G-Clamp
(pair)
Medium Crosshead
Screwdriver
Hammer
Tape Measure
Bradawl
Large Flathead
Screwdriver
150101
4
3.5x12mm
150202
14
4x12mm
154082
10
4x15mm
150201
22
150308
2
150309
2
154047
2
A
A
B
B
C
D
D
4x25mm
150124
8
154014
2
154015
2
Note: Supports D not used if fitting drawer.
1
2
1 2
1 2
1
2
1 2
A
1
2
1
2
1
2
1
2
1
2
A
2
10
154004
2
1
1
154082
10
3
8
150124
3
3
3
3
3
A
D
619mm
50mm
Note: Left hand panel shown only, mirror
for right hand panel.
4
A
619mm
619mm
70mm
400mm
4
Drawer runner
684mm
4
4
150202
154068
4
4
Note: Left hand panel shown only, mirror
for right hand panel.
3.5 x 16mm
x2
x4
Fit as third screw
Front
1 x 'L'; 1 x 'R'
Drawer Runner
Caution: Some pieces of hardware could be hazardous to small children. Keep all these items out of reach and do not leave children unattended in the assembly area.
Please read these instructions carefully before proceeding. Refer to the Guide to Receiving and Installing your Kitchen booklet for further information.
Note:
Due to variation in wall conditions no screws are supplied for fixing the units to the wall. If in doubt consult an expert. Assemble the unit on a clean solid work surface.
In the interest of continuing improvements we reserve the right to amend or adjust the specifications without prior notice. Errors and omissions excepted.
These units may be fitted with a drawer system. The drawers are supplied separately. These instructions show the runner positions for the drawer system.
Follow the instructions supplied with the drawers for drawerbox assembly.
Every effort has been made to ensure that this product leaves the factory in perfect condition. In the unlikely event that an item is damaged or incorrect, please contact the customer services department.
Note - Fitting Handles:
(1) Decide where you are going to position each handle to maintain symmetry around your kitchen. (2) Measure the handle centres and mark off each door/drawer position. (3) Drill through the door/drawer
using a fine drill (<2.5mm), then drill back from the rear face using a 4.5mm drill. (4) Attach with the fixings provided with your handle.
FM 665131
Note: If fitting a “True Handleless” kitchen, some
components will differ to those shown in this instruction
and will also be packaged separately. Please refer to your
True Handleless guide to Receiving for further details on
the different components and difference in installation.
TH
TH
Modification required at this stage, see True
Handleless guide for further details.
Note: For ease of fitting, Step 17 can
be completed at this point.
