Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
71
Configuration of the System via the Service Interface – Chapter 10
Figure 33
Menu: (Y) display Histogram
The channel numbers are shown on the horizontal axis, each column representing a
coil. On the vertical axis, the dimensionless received strength is shown. A voltage is
represented by a bar of "O"s. The values have already been converted with the cor
-
rection values.
Directly below the axis label, the symbols <<<<|>>>> indicate which values are used
for the respective distance calculation.
Below this line, the calculated distance with minimum value, instantaneous value,
maximum value and the maximum difference between minimum and maximum
value is displayed in [mm].
To exit the menu:
Press any key.
The main menu is shown.
10.2.13 (W)rite Transponder
The
(W)rite Transponder
menu allows you to program transponders in the antenna
field (at nominal reading distance).
Optionally, you can program transponders using the corresponding system com
-
mand (see Table 10 on page 38 and Table 20 on page 44).
To switch from the main menu to the menu
(W)rite Transponder
:
Press the key
.
To program the transponders.
Enter the 5-digit code in hexadecimal format.
Start the programming with
.
10.2.14 (L)oad values to EEProm
With the menu
(L)oad values to EEProm
you store the parameters in the non-volatile
memory.
To switch from the main menu to the menu
(L)oad values to EEProm
menu:
Press the key
.
Y_Histogram, press any key to return
dev. Y dev. X
>1000:................ >1000:................
> 900:................ > 900:................
> 800:................ > 800:................
> 700:................ > 700:................
> 600:................ > 600:................
> 500:................ > 500:................
> 400:........oo...... > 400:........ooo.....
> 300:......oOOOOo.... > 300:......oOOOOo....
> 200:.....OOOOOOOO... > 200:......OOOOOOO...
> 100:....oOOOOOOOO... > 100:.....OOOOOOOOo..
---+---+---+---+ ---+---+---+---+
