GMM-NT (MG-Navtracker) - Installation Guide
Programming your MG Nav-Tracker control box
The MG Nav-Tracker requires the use of two of the
Marine Magellan’s PGM outputs and one zone. One the
backside upper right hand corner of the control box, you will
see two serial numbers one on top of the other. You can
program these serial numbers through Sectional
Programming of the Marine Magellan.
1.
Enter Sectional programming by holding down
the “0” key for four seconds. It will prompt you
for a password. Enter “1 1 1 1”. It now prompts
you for a section number “Section [ ]”
2.
You must now program the serial numbers of the
PGM into the panel to initialize the geofence and
alarm notifications. Typically we allocate PGM 3
(Section 237) and PGM 4 (Section 238) to this.
Enter Section “237” on the screen. You will now
be prompted for a 6 digit number (Figure 6).
Enter the serial number on the very top right
corner (upper) on the back of the Nav-Tracker
Control Box. After you enter the number it will go
directly to section “238”. Enter the second serial
on the top right corner (lower) in this section
(Figure 6).
3.
Continue to press “#’ until you are prompted to
the blank section number again. Now press exit,
you are done in sectional programming.
4.
Once you are out of sectional programming the
screen should say “Ready to Arm”. Press Menu
and go “4-system setup” enter your installer or
maintenance code (default 0000 and 1111). Go to
“7 - Output Profile”. Press “ok” and continue to
next step.
5.
Press next until you see “Modify Output 3” and
press “ok”. It then asks “Delete Output”, select
“no”. “Modify Label”, select “yes” and label this
Output “Geofence Initialization”. “Label OK?”
select yes. For the type, continue pressing next
until you see “Follow Arm”. This will wirelessly
initialize the geofence whenever the system is
armed. Next you are prompted for “Remote
Access”, select “no”. Finally, you are asked if
you want to program “Another Output”; select
“yes”
6.
You are now brought to “Modify Output 4”, select
“ok”. It then asks “delete output”, select “no”.
“Modify Label”, select “yes” and label this
Output “Alarm”. For the type, continue pressing
next until you see “Alarm Activation” press “ok”
and select “Follow Alarm”. This will send out an
alarm notification through the Nav-Tracker
whenever the system is in alarm. “Another
Output” select “no”.
7.
Press exit until you get back to the main screen.
The MG-Nav-Tracker is now programmed to your
Marine Magellan system.
Figure 6
