Gorenje RK6355W1, Инструкция по эксплуатации, Страница: 10 / 40

Instructions for Use 10
Ice Making
(certain models only)
Recommended thermostat position for ice
making is on the middle setting. Fill two
thirds of the ice tray with cold water or any
other liquid convenient for freezing. Insert
the ice tray into the guides or on the cooling
plate. Time required for the ice to form,
largely depends on ambient temperature,
thermostat setting and on how often you
open the door. It usually takes 2-6 hours
(depends on which model of refrigerator you
have). With smaller refrigerators we
recommend you make a stock of ice cubes
(store them in a separate plastic box). The
easiest way to empty the ice tray is to turn
the tray around, pour it with cold water and
slightly twist it (bend it).
Changing the Direction of Opening the Door
If you find the direction of opening the door on
your appliance inconvenient, you can change
it. Holes on the opposite side have already
been prepared in the factory.

Unscrew the kick-plate and remove it by
pushing downwards.

Unscrew the lower hinge and take off the
lower door together with the middle hinge
washer.

Unscrew the middle hinge and take off the
upper door together with the upper hinge
washer. Remove the fastener on the
opposite side of the appliance (on the place
where the middle hinge is fixed).

Unscrew the upper hinge fastener and fix it
on the opposite side of the appliance.

Take off, change and replace the door hinge
fixture and the fixture plugs.

Put the upper hinge washer and the upper
door on the upper hinge fastener.

Rotate the middle hinge for 180° and fix it on
the opposite side of the appliance. Put the
middle hinge washer and the lower door on
the hinge from the lower side.

Put the lower hinge on the lower door and fix
it.

Replace the cover plate of the lower hinge to
the opposite side of the kick-plate and place
it to the appliance.

In case your appliance is equipped with a
handle mounted on the side of the
appliance, take it off and replace it on the
other side. (If there is more than one handle,
replace them all, following the same
procedure.)

Some screws are covered with caps. Take
them off before undoing the screws.

Use the decorative caps and plug the
remaining middle hinge holes as well as the
remaining holes of the side handles (if you
have a model with side handles).

Check the gasket, it shouldn't be creased
and it should seal well. Should the seal not
adhere to the casing of the appliance
perfectly, it will have to be heated from a
suitable distance (by means of hair drier, for
example) and lightly stretched to the
required height.