Gorenje RI4181AW, Инструкция по эксплуатации, Страница: 23 / 24

394731
Fault: Cause/Remedy
The appliance does not
operate after connection to the
mains: • Check if there is power in the socket and if the appliance is
switched on.
Cooling system operates
continuously without
intermittent stoppages: • Ambient temperature too high.
• Frequent opening of the door, door open too long.
• Door not closed properly (particle between door gasket, sagged
door, check gasket sealing, etc...).
• Excessive quantity of fresh food inserted at once.
• Refrigerator probe (A) is clogged with fresh food. Relocate the
food to provide air circulation around the probe (certain models
only).
• Check air circulation for suf
fi cient cooling of the compressor, and
clean the condenser.
Excessive ice formation at the
rear interior wall of the freezer: • Frequent opening of the door, door open too long.
• Inserting hot food in the freezer.
• Food or dish is touching the rear interior panel of the refrigerator.
• Bad door sealing; clean or replace the gasket if dirty or damaged.
Water dripping from the
appliance: • Drain outlet is clogged, drain water drips past the collection
groove.
• Clean the clogged outlet using plastic straw.
• Thaw thick ice deposits manually (see chapter Defrosting).
Flashing signal light D :
(only for the freezer
compartment)
• Door opened too frequently or too long.
• Door not closed correctly (possible impurities on the seal,
misaligned door, damaged seal, etc.).
• A longer power failure.
• Too much fresh food inserted at once.
Bulb replacement: • Before replacing the light bulb, disconnect the appliance form the
power supply (pull the power cord from the wall socket).
Insert the screwdriver into the cover slot, lift it and remove the
cover.
Replace the bulb with the equivalent new bulb (E 14, same
voltage as the original one) and replace the cover back to its
position.
• Don’t forget: the old bulb does not belong to organic waste.
• Light bulb is consumption material and is not covered by the
warranty!
• Bulb lamps used in this appliance are special purpose lamps
selected for household appliances use only. They are not suitable
for household room illumination.
Signal light B is fl ashing: • If the signal light B is fl ashing, call a service technician.
Error code indicated on
the display (only with some
models): • If “ E ” appears on the display, call a service technician.
If none of the above reasons seems to match your problem, please contact the nearest service
center and state the type, model and serial number as indicated on the label with basic information
attached in the appliance interior.
23
Troubleshooting guide